Differences

This shows you the differences between two versions of the page.

--- phase_1_-_3d_printed_enclosure [2026/08/29 18:03] – [Introduction] walkeradmin
+++ phase_1_-_3d_printed_enclosure [2026/09/11 07:43] (current) – [Introduction] walkeradmin
@@ Line 18: / Line 18: @@
 {{ :pico-lcd-3dprint-01.jpg?500 |}}
 \\
-I placed the buttons along the top so that the legs of the buttons sat directly over the pins of the buttons, this had two advantages.
+I placed the buttons along the top so that the legs of the buttons sat directly over the pins of the Pico, this had two advantages.
-The wiring is so much simpler
+  * The wiring is so much simpler.
-The buttons hold down the Pico in the case.
+  * The buttons hold down the Pico in the case.
 Now, we just need to solder the four wires between the Pico and the LCD, which  you cannot see because they are all hidden behind the Pico/LCD.