Differences

This shows you the differences between two versions of the page.

--- new_3d_printed_enclosure [2026/09/10 13:25] – [Introduction] walkeradmin
+++ new_3d_printed_enclosure [2026/09/10 13:39] (current) – [Assembly] walkeradmin
@@ Line 32: / Line 32: @@
 Locator Pins (you'll need 6)
 \\
-{{ :phase2-case-pin.png?400 |}}
+{{ :phase2-case-pin.png?200 |}}
+----
+==== Assembly ====
+\\
+{{ :wifianalyzerwiring.jpeg?500 |}}
+\\
+\\
+So the hardest part is getting the pins in to the Pico. I have made the pins smaller, but you will have to glue them in, but at least they won't snap when you press them in. I would do the following:
+  * Put the cable on the LCD Pins
+  * Fix the LCD to the Box
+  * Put the Pins on the Pico (take note, solder the Pico Pins on top of the unit, not the bottom)
+  * Fix the Pico in using just the pins at the rear
+  * The box uses brass M3x4x5 Threaded Heat Inserts.
+That's it, your Wifi Analyzer project should look pretty good in it's new home.
+\\
+\\
 ----