Differences

This shows you the differences between two versions of the page.

--- new_3d_printed_enclosure [2026/09/07 18:01] – [Introduction] walkeradmin
+++ new_3d_printed_enclosure [2026/09/10 13:39] (current) – [Assembly] walkeradmin
@@ Line 7: / Line 7: @@
 ===== Introduction =====
 \\
-Oh No!!! You are a bit early. I hope if you got to this page that you have built the hardware and tested the software and have had it running on your desk for a while, if so WELL DONE, seriously.
+Well, here it is. I did do a couple of versions of this, but this is the one I prefer, even though it is a little tricky to put together. Here is the design.
 \\
 \\
-Target to get the 3D enclosure uploaded here, Mid-Sept-2026.
+You can download the STL file {{ :phase_2_frame_mount_pico_plus_lid.zip |HERE}}.
 \\
 \\
-It will look a bit like the picture below (oh come on, it will be way cooler lol)
 \\
 \\
-{{ :undefined:3d-enclosure-wifi-analyser-mock-up.jpeg?500 |}}
+Front View
 \\
-Now if you think my design sucks, then you don't have to use it, design something cool and funky of your own :) Whatever you do, have some fun :)
+{{ :phase2-case-enclosure.png?500 |}}
+\\
+\\
+Internal View
+\\
+{{ :phase2-case-enclosure-rear-view.png?500 |}}
+\\
+\\
+Rear Panel
+\\
+{{ :phase2-case-rear-panel.png?500 |}}
+\\
+\\
+Locator Pins (you'll need 6)
+\\
+{{ :phase2-case-pin.png?200 |}}
+----
+==== Assembly ====
+\\
+{{ :wifianalyzerwiring.jpeg?500 |}}
+\\
+\\
+So the hardest part is getting the pins in to the Pico. I have made the pins smaller, but you will have to glue them in, but at least they won't snap when you press them in. I would do the following:
+  * Put the cable on the LCD Pins
+  * Fix the LCD to the Box
+  * Put the Pins on the Pico (take note, solder the Pico Pins on top of the unit, not the bottom)
+  * Fix the Pico in using just the pins at the rear
+  * The box uses brass M3x4x5 Threaded Heat Inserts.
+That's it, your Wifi Analyzer project should look pretty good in it's new home.
 \\
 \\
-{{ :raspberry-pi-pico-pinout-diagram.svg |}}
 ----