This is an old revision of the document!

New 3D Printed Enclosure

Aug 2026

Introduction

Oh No!!! You are a bit early. I hope if you got to this page that you have built the hardware and tested the software and have had it running on your desk for a while, if so WELL DONE, seriously.

Target to get the 3D enclosure uploaded here, Mid-Sept-2026.

It will look a bit like the picture below (oh come on, it will be way cooler lol)

Now if you think my design sucks, then you don't have to use it, design something cool and funky of your own :) Whatever you do, have some fun :)