WalkerWiki - wiki.alanwalker.uk

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== New 3D Printed Enclosure ======
<color #db5f0b>Sep 2026</color>
\\ 
\\ 
{{ :micro-python.png?100 |}}
----
===== Introduction =====
\\ 
Well, here it is. I did do a couple of versions of this, but this is the one I prefer, even though it is a little tricky to put together. Here is the design.
\\ 
\\ 
You can download the STL file {{ :phase_2_frame_mount_pico_plus_lid.zip |HERE}}.
\\ 
\\ 
\\ 
\\ 
Front View
\\ 
{{ :phase2-case-enclosure.png?500 |}}
\\ 
\\ 
Internal View
\\ 
{{ :phase2-case-enclosure-rear-view.png?500 |}}
\\ 
\\ 
Rear Panel
\\ 
{{ :phase2-case-rear-panel.png?500 |}}
\\ 
\\ 
Locator Pins (you'll need 6)
\\ 
{{ :phase2-case-pin.png?200 |}}
----
==== Assembly ====
\\ 
{{ :wifianalyzerwiring.jpeg?500 |}}
\\ 
\\ 
So the hardest part is getting the pins in to the Pico. I have made the pins smaller, but you will have to glue them in, but at least they won't snap when you press them in. I would do the following:

  * Put the cable on the LCD Pins
  * Fix the LCD to the Box
  * Put the Pins on the Pico (take note, solder the Pico Pins on top of the unit, not the bottom)
  * Fix the Pico in using just the pins at the rear
  * The box uses brass M3x4x5 Threaded Heat Inserts.

That's it, your Wifi Analyzer project should look pretty good in it's new home.
\\ 
\\ 
----