Differences

This shows you the differences between two versions of the page.

--- led_pwm_control [2017/01/23 19:00] – [LED States] walkeradmin
+++ led_pwm_control [2024/10/02 15:50] (current) – ↷ Links adapted because of a move operation walkeradmin
@@ Line 2: / Line 2: @@
 <color #db5f0b>Jan 2017</color>
 \\
+\\
+{{:led_blink_320.gif?150|}}
 ----
 Turning on LEDs using the GPIO on the Raspberry Pi is pretty simple. You just turn on or off the relevant GPIO pin, and your LED (connected via a 330r resistor) will come on and go off.
@@ Line 22: / Line 23: @@
 ==== Using PWM from the Command Line ====
 \\
-I have not used this in Python yet, so for now I am doing it from the command line, using the [[gpio_control_from_command_line|WiringPi]] libraries. Check out the [[gpio_control_from_command_line|WiringPi]] page if you need to set this up (takes about 20 seconds).
+I have not used this in Python yet, so for now I am doing it from the command line, using the [[corporate:gpio_control_from_command_line|WiringPi]] libraries. Check out the [[corporate:gpio_control_from_command_line|WiringPi]] page if you need to set this up (takes about 20 seconds).
 \\
 \\
@@ Line 86: / Line 87: @@
 \\
 \\
-----------PWM-001------------PWM-010------------PWM-050------------PWM-0100------------PWM-250------------PWM-500------------PWM-999------------
+---------PWM-001------------PWM-010------------PWM-050------------PWM-0100--------------PWM-250--------------PWM-500--------------PWM-999--------