Differences

This shows you the differences between two versions of the page.

--- firmware_install [2026/07/19 14:37] – [Introduction] walkeradmin
+++ firmware_install [2026/07/19 16:05] (current) – [Quick Test] walkeradmin
@@ Line 33: / Line 33: @@
 \\
 \\
+Once the unit reboots, it will come back and the onboard LED will be illuminated White (or a very light blue, not sure).
+\\
+\\
+{{ :waveshare-firmware-install-003.jpg?400 |}}
+\\
+\\
+That is the firmware installation complete.
+\\
+\\
+----
+==== Quick Test ====
+When the firmware was installed, a file called main.py was created, and when the RP2040 rebooted, this file ran at boot.
+\\
+\\
+This is what causes the LED to end up a white colour. However, if you press the RESET button, the device will reboot and you will see the code main.py does a bit more.
+\\
+\\
+{{ :rp2040-neopixel_edit.mp4?480 |}}
+\\
+Here we can see that the LED flashes from Red to Green to Blue, then goes to a static White.
+\\
+\\
+----