Differences

This shows you the differences between two versions of the page.

--- create_vswitch [2017/07/19 07:55] – [Create vSwitch] walkeradmin
+++ create_vswitch [2017/07/24 06:07] (current) – walkeradmin
@@ Line 11: / Line 11: @@
 \\
 \\
-{{ ::vmware_architecture.png?600 |}}
+{{ ::vmware_architecture.jpg?600 |}}
 \\
 \\
@@ Line 22: / Line 22: @@
 \\
 \\
-{{ :vswitch_and_port_groups_001.png?600 |}}
+{{ :vswitch_and_port_groups_001.jpg?700 |}}
 \\
 \\
-In the left hand pane, click the Networking link.
+In the left hand pane, click the <color #ed1c24>Networking link</color>.
+\\
+\\
+From the main page, select <color #ed1c24>Physical NICs</color>. You should have a page similar to the one above where all of your physical interfaces are listed. It is important to check these first because you can check which interfaces you have, and which are connected. Remember which interface from this list you will use.
+\\
+\\
+At the top of the page, select <color #ed1c24>Virtual Switches</color>.
+\\
+\\
+{{ :vswitch_and_port_groups_002.jpg?700 |}}
+\\
+\\
+Here we can see any vSwitches that have already been created (<color #ed1c24>vSwitch0</color> will be there by default, and is used by the management interface of VMWare).
+\\
+\\
+Click <color #ed1c24>Add standard virtual switch</color>.
+\\
+\\
+{{ :vswitch_and_port_groups_003.jpg?600 |}}
+\\
+\\
+A pop up will open to enter some data. We need to specify the following:
+\\
+\\
+**vSwitch Name:** Any name you want, I have used Data_Network.\\
+**MTU:** Unless you have a good reason, leave this at 1500\\
+**Uplink1:** This is a drop down list, select the correct physical server interface.\\
+\\
+Click <color #ed1c24>Add</color>.
+\\
+\\
+You will now see your vSwitch listed in the main Networking page.
+\\
+\\
+{{ :vswitch_and_port_groups_004.jpg?700 |}}
+\\
+\\
+We have now created a vSwitch, and looking at our architecture, we can see below what we have completed.
+\\
+\\
+{{ :vmware_architecture_vswitch_only.jpg?600 |}}
+\\
+The next step would be to add some <color #ed1c24>Port Groups</color>.
 \\
 \\
-From the main page, select Physical NICs